Dodge ZB 2005 Service Manual page 138

ZB
BRAKE PADS/SHOES - FRONT/REAR (Continued)
Fig. 9 Removing Upper Support Pin
1 - HAMMER
2 - CALIPER ASSEMBLY
3 - SUPPORT PIN
4 - PUNCH
(c) Place a second trim stick between outboard
brake shoe and rotor, then repeat above procedure.
Fig. 10 Pushing Back Caliper Pistons
1 - BRAKING DISC
2 - BRAKE PADS
3 - TRIM STICK TOOL
4 - CALIPER ASSEMBLY
(7) Remove inboard and outboard brake shoes
through opening in caliper (Fig. 11).
Fig. 11 Brake Shoe Removal/Installation
1 - CALIPER ASSEMBLY
2 - INBOARD BRAKE SHOE ASSEMBLY
(8) Once brake shoes are removed from caliper,
inspect caliper pistons and dust boot areas on caliper
halves for evidence of brake fluid leakage (Fig. 12).
Also inspect dust boots on all caliper pistons for any
cuts, tears or heat cracks and brake shoe supports
for excess wear or damage. If caliper fails inspection,
it should be removed,
inspected and have new piston seals and dust boots
installed on all pistons within caliper. (Refer to 5 -
BRAKES/HYDRAULIC/MECHANICAL/DISC
BRAKE CALIPERS - REMOVAL)
BRAKES - BASE 5 - 13
disassembled, cleaned,