Network Communication Setup - Xerox 5222 System Administration Manual

Test Internet Fax
An Internet Fax job should be submitted to make sure that the machine has been
installed and configured correctly.

Network Communication Setup

NOTE: Some of the configuration options for this protocol are only available from
CentreWare Internet Services. Refer to
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP
network.
Initially, activate the port.
1.
Connect the machine to the network.
2.
Press the <Log In/Out> button on the control panel, and then type the System
Administrator login ID to enter the System Administration mode.
NOTE: The passcode may also be required depending on the machine configuration.
3.
Press the <Machine Status> button on the control panel, and then select the
[Tools] tab on the screen.
4.
Select [System Settings] in the menu at the left side of the screen.
5.
Select [Connectivity & Network Setup] in the [Group] menu.
6.
Select [Port Settings] in the [Features] menu.
7.
Select [Receive E-mail] and then [Change Settings].
8.
Select [Port Status] and then [Change Settings].
9.
Select [Enabled] and then [Save].
10.
On the [Port Settings] screen, select [Send E-mail] and then [Change Settings].
11.
Select [Port Status] and then [Change Settings].
12.
Select [Enabled] and then [Save].
Next, establish TCP/IP.
1.
Select [Connectivity & Network Setup] in the [Group] menu, and then select
[Protocol Settings] in the [Features] menu.
2.
Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].
When [IPv4 Mode] or [Dual Stack] is selected in step 2
3.
Select [IP Address Resolution], and then [Change Settings].
4.
Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],
[DHCP/Autonet], and [STATIC], and then select [Save].
NOTE: Use the DHCP server together with the Windows Internet Name Server
(WINS) server.
If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocol
settings. Otherwise, proceed to step 11.
5.
Select [IPv4 - IP Address], and then [Change Settings].
6.
Use the keypad on the screen to enter an IP address for the machine in the format
"xxx.xxx.xxx.xxx". When you have finished entering all values, select [Save].
CentreWare Internet Services on page 147
Internet Fax Installation
.
289