Xerox 5222 System Administration Manual page 390

15 Problem Solving
Code
016-706
016-707
016-708
016-710
016-711
016-712
016-713
016-714
016-716
016-717
016-718
016-719
016-720
016-721
016-722
016-723
016-724
016-725
390
The hard disk ran out of space, because the number of Secure Print users
reached its maximum. Delete unnecessary Secure Print jobs from the machine.
The Sample Print feature is not available due to a malfunction of the hard disk.
Contact the Xerox Welcome Center.
An annotation cannot be added due to insufficient hard disk space. Delete
unnecessary documents from the disk.
The Delayed Print job could not be executed. Take one of the following actions:
• Delete unnecessary data from the hard disk to increase free space.
• Reset the settings of Print to Mailbox and Sample Print.
• Reduce the number of stored Delayed Print jobs to less than 100 jobs.
Refer to 016-985.
Refer to 003-751.
The entered mailbox passcode is not correct. Enter the correct passcode.
The specified mailbox does not exist. Create a new mailbox or specify an
existing mailbox.
The TIFF file could not be spooled as the size of the file exceeded the remaining
space on disk. Increase the size of the PCL form area.
A [Transmission Report - Job Undelivered] or [Activity Report] was requested,
but the information was not in memory. Take one of the following actions:
• Divide Internet Fax document pages to reduce the size of a job, to increase
memory and HDD's free space.
• Execute a new scan job or an Internet Fax job after scan and Internet Fax
jobs stored in the memory space are finished.
• Output a report before 200 or more jobs are logged.
Unable to process PCL print data due to insufficient memory. Take one of the
following actions:
• Lower the resolution.
• Cancel the Multiple-Up or 2 Sided Print feature, and try again.
Unable to process PCL print data due to insufficient print page buffer memory.
Increase the print page buffer.
The PCL print data contains an invalid command. Check the print data, and then
try again.
A print error occurred. The Auto Tray Switching setting conflicts with the Paper
Type Priority settings. When the Auto Tray Switching feature is enabled, select
an option other than [Auto Paper Off] for trays on the [Paper Type Priority]
screen.
The specified staple position is not supported. Change the staple position, and
try again.
The specified hole-punch position is not supported. Change the hole-punch
position, and try again.
The specified staple and hole-punch positions are not a valid combination.
A scanned document saved in a mailbox could not be converted to fax data
using the job flow sheet. Send the document not by using the Job Flow Sheets
service, but by using Fax service.
Description and Remedy