Microsoft Networking; Information Checklist - Xerox 5222 System Administration Manual

Test Print
To make sure that the machine has been installed on the network correctly, a test print
should be submitted from each client computer. Perform the following steps.
1.
Open a sample document on a client computer.
2.
Select the machine using the Chooser (Mac OS 9.2) or the Print Center (Mac OS
X 10.x).
3.
Print the document on the machine and verify that it prints correctly.
4.
Make sure that the driver is installed on every computer that will be sending jobs
to the machine.
5.
Repeat the test for all computers that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to

Microsoft Networking

This section explains how to set up the machine to operate on a Microsoft network. The
following information is provided:
Information Checklist – page 251
SMB Environments – page 252
SMB Installation – page 252
Installation Procedure – page 252
Network Communication Setup – page 253
Computer Setup – page 255
Test Print – page 255

Information Checklist

Before starting the Microsoft networking installation procedures, make sure that the
following items are available or have been performed.
An existing operational Microsoft network is required. These procedures
are not designed to install a Microsoft network.
Obtain and record the following information, if required:
• IP address
• Gateway address
• Subnet mask (for IPv4) / Prefix (for IPv6)
• Host name
Test the machine to make sure that it is fully installed and functioning
correctly.
Install the print driver.
If problems are encountered during the installation, refer to
page 341
Problem Solving on page 341
.
Item
Microsoft Networking
.
By
Customer
Customer
Customer
Customer
Problem Solving on
251