Table of Contents
Advertisement
Code
034-511
An error occurred during relay broadcasting. Check that the relay station is
correctly registered with the speed dial code. Also, check the destination
numbers registered at the relay station.
034-512
An endless loop was detected in the remote relay broadcasting. Check that the
relay station is correctly registered with the speed dial code. Also, check the
destination numbers registered at the relay station.
034-513
Received an invalid command. This is a Xerox remote maintenance system
operational error. No user action is required.
034-514
Received an unsupported request. This is a Xerox remote maintenance system
operational error. No user action is required.
034-515
There is a problem on the remote machine. Check the remote machine status.
034-519
The number of broadcasting destinations exceeded the limit value. Wait until the
active and pending jobs are completed, or reduce the number of destinations,
and then try again.
034-520
The number of active and pending jobs exceeded the limit value. Wait until the
jobs are completed, and then try again.
034-521
An internal error occurred. Switch off the machine, and then switch it on again.
Contact the Xerox Welcome Center if the problem persists.
034-522
There is no telephone line available for manual fax transmission. Wait until the
job in progress is completed, and try again.
034-523
The destination machine is too busy to accept your fax. Wait a while, and then
try again.
034-527
A dial control error occurred. Switch off the machine, and then switch it on
again. Contact the Xerox Welcome Center if the problem persists.
034-528
Manual fax transmission is not available while the machine is in dialing mode.
Wait a while, and then try again.
034-529
The received document cannot be printed using the paper loaded on the
machine. Try one of the following.
• Check that the proper size paper is loaded on the machine.
• Check that the trays are correctly installed and detected on the machine.
034-530
Operation timed out. Perform the operation within the specified time frame.
034-550
An error occurred during writing to the FaxCard-ROM. Contact the Xerox
Welcome Center.
034-700
The G3 DP (Dial Pulse) connection timed out. Switch off the machine, and then
switch it on again. Contact the Xerox Welcome Center if the problem persists.
034-701
The software needs to be reset. Switch off the machine, and then switch it on
again. Contact the Xerox Welcome Center if the problem persists.
034-702
Communication failed due to an incorrect fax number. Check the number, and
try again. If a speed dial button was used, check the correct number is
registered with the button.
034-728
An invalid number was specified. Check the destination number, and try again.
Contact the Xerox Welcome Center if the problem persists.
034-730
Refer to 034-508.
034-731
Description and Remedy
Fault Codes
413
Hide quick links:
Advertisement
Table of Contents
