Netware; Information Checklist; Netware Environments - Xerox 5222 System Administration Manual

8 Printer Environment Settings

NetWare

This section explains how to install the machine onto a NetWare network. The following
information is provided:
Information Checklist – page 228
NetWare Environments – page 228
NetWare Installation – page 229
Installation Procedure – page 229
Network Communication Setup – page 230
NetWare Setup – page 231
Computer Setup – page 231
Test Print – page 231

Information Checklist

Before installing the machine onto a network, make sure that the following items are
available or have been performed.
An existing operational NetWare network is required. These procedures
are not designed to install a NetWare network.
NetWare versions 3.x, 4.x, 5.x or 6.x
Obtain and record the following information, if required:
• IPv4 address
• Gateway address
• Subnet mask
• Host name
NOTE: Only the IPv4 format is available for addresses.
Test the machine to make sure that it is fully installed and functioning
correctly.
Install the print driver.
If problems arise during the machine installation, refer to
for assistance.

NetWare Environments

System configuration
The machine supports NetWare PServer mode in Bindery or NDS. NetWare 3.x/4.x/
5.x/6.x is required to support Bindery. NetWare 4.11 or later is required to support NDS.
In the PServer mode, the machine will function as a print server and print jobs from the
print queue. The machine uses one file server user license.
NOTE: The machine does not support RPrinter mode.
228
Item By
Customer
Customer
Customer
Customer
Customer
Problem Solving on page 341
.