Xerox 5222 System Administration Manual page 361

Symptom
Misregistration on a double-sided copy of
business cards.
Output does not reflect the selections made
on the touch screen.
The finisher does not stack output correctly.
Pages in the set are not stapled.
Paper delivered to an output tray is not
properly stacked up.
Paper curls.
Cannot store a document for secure polling
due to full memory.
Recommendation
When printing a name card from Tray 5
(Bypass Tray), the lead edge registration
may be different between side 1 and side 2
(maximum 4.4 mm).
• Adjust the position of the image on the
output copy paper. Refer to Image Shift in
the Copy chapter of the User Guide.
• Select [Save] after each selection on the
touch screen, if available.
• Check that the paper tray guides are
locked into position against the paper.
• Check that the paper tray guides are
locked into position against the paper.
• Flip over the paper stack in the paper tray,
or rotate it head to toe.
• Check that the paper is loaded correctly.
Load paper in Trays 1, 2, 3 and 4 seam
side up.
• Load paper in the High Capacity Tandem
Tray and bypass tray seam side down.
• Load custom media in the bypass tray.
Paper and Other Media on
• Refer to
page 17 for procedures.
• Cancel the operation, then repeat the
same operation later when additional
memory is available.
Common Problems
361