Xerox 5222 System Administration Manual page 394

15 Problem Solving
Code
016-786
016-787
016-788
016-789
016-791
016-792
016-793
016-794
016-795
016-796
016-797
016-798
016-799
016-981
016-982
016-985
018-400
018-500
394
The scanned data could not be written due to insufficient space on the hard disk.
Delete unnecessary data, or initialize the hard disk if the saved data are not
needed.
The server IP address set to the job template is incorrect. Specify the correct job
template.
Failed to retrieve the file from the web browser. Take one of the following
actions, and then try retrieving again.
• Refresh the browser page.
• Restart the browser.
• Switch the machine off and then back on.
The mail processing was interrupted due to insufficient hard disk space. Lower
the image resolution or reduction/enlargement ratio, or divide the document into
smaller segments to send.
Access to the destination for the Scan to PC service or to the Network Scanning
server application failed. Check if you are authorized to access the specified
destination or server.
A job history report was to be printed, but the specified job history could not be
retrieved. The specified job history is not available.
The hard disk has run out of space. Delete unnecessary data, or initialize the
hard disk if the saved data is not needed.
The media was incorrectly inserted. Insert the media correctly.
A read error occurred on the media. Check the contents stored on the media
using a computer.
The print job could not be processed. The hard disk drive or memory may not be
installed properly on the machine, or may be damaged. Contact the Xerox
Welcome Center.
The print data contains invalid parameters. Check the print data and print
options, and try printing again.
A HDD access error occurred. The HDD is full. Divide pages to reduce the size
of a job, or lower the resolution. Or, delete unnecessary Secure-Print, Delayed-
Print, pending-fax, or mailbox documents to increase the HDD free space.
The hard disk has run out of space. Delete unnecessary data from the hard disk
or documents in mailboxes.
The e-mail size exceeded the maximum size. Try one of the following
procedures, and resend the e-mail.
• Reduce the number of document pages.
• Lower the scan resolution using [Resolution].
• Reduce the document size using [Reduce/Enlarge].
• Increase the maximum value using [Maximum E-mail Size] on the [Tools]
screen.
An IPSec setting error occurred. The preshared key or device certificate, which
is required for the selected authentication method, is not specified. Specify the
preshared key or device certificate according to the authentication method.
The job cannot be printed with the specified print parameter combination (i.e.,
file size, paper size, paper tray, 2-sided print request, output tray, etc.). Set the
appropriate combination of print parameters and try again.
Description and Remedy