Table of Contents
Advertisement
Use This Chapter
Read this
chapter for:
•
1756-CN2, 1756-CN2R modules
•
1756-CNB, 1756-CNBR modules
•
1769-L32C, 1769-L35CR controllers
•
1784-PCIC, 1784-PCICS,
1784-PKTCS cards
•
1788-CNx cards
•
1794-ACN15, 1794-ACNR15 adapters
•
1797-ACNR15 adapter
1
Configure a ControlNet Module
This chapter describes how to configure a ControlNet communication module
to operate on a ControlNet network.
For This Information
Set Up Your Computer to Connect to ControlNet
Use RSLogix 5000 Software
Add a Local ControlNet Module
Add a Remote ControlNet Module
Download the Project to the Logix5000 Controller
Use RSNetWorx for ControlNet Software
Schedule a ControlNet Network for the First Time
Schedule the Network Offline
Schedule the Network Online
Reschedule a ControlNet Network That Has Previously
Been Scheduled
The example configuration process shown in this chapter
IMPORTANT
uses a ControlLogix ControlNet Bridge module
(1756-CNB) in a ControlLogix controller project.
However, the overall configuration process (briefly
described in the section Overview of the RSLogix 5000
Software Configuration Process) generally applies to any of
the ControlNet communication modules covered by this
manual.
To configure a ControlNet communication module to operate on the
ControlNet network, you must:
• connect your computer to the RSLogix 5000 project via an RSLinx
ControlNet software communication driver.
• add the ControlNet communication module to your RSLogix 5000
project.
• schedule the ControlNet network via RSNetWorx for ControlNet
software.
Chapter
See Page
3-2
3-2
3-3
3-7
3-10
3-12
3-12
3-13
3-19
3-23
Publication CNET-UM001C-EN-P - November 2005
3
Hide quick links:
Advertisement
Table of Contents
