About This Chapter
Rockwell Automation Publication 1732E-UM007A-EN-E - August 2016
Configure the ArmorBlock I/O 8 Channel
IO-Link Master Module Using the Studio 5000
Add-on Profile
Before you can use your ArmorBlock I/O 8 Channel IO-Link Master in
Studio 5000, you must set up the module profile so that it can be recognized.
Follow these steps to set up the profile.
The illustrations of the Studio 5000 Module Profile Setup software
IMPORTANT
dialog boxes shown in this manual are samples.
Because your system configurations or the firmware kits are
different, the dialog boxes you see when running the tool may be
different from the ones you see here
Install the 1732E-8IOLM12R Add-On Profile
1. In the installation package, double-click MPSetup.exe. The Welcome
dialog box appears. Click Next
4
Chapter
33