Route A Controlnet Message - Rockwell Automation Allen-Bradley ControlNet 1734-ACNR User Manual

Double-click on Set up Screen.
A. Type the Communication Command.
Use either PLC-5 Typed Read or PLC-5
Typed Write.
B. Type the starting address of the data
in this PLC-5 controller, the controller
sending the message.
C. Type the number of elements to write
or read in Size in Elements.
D. Type the Port Number (always 2).
E. Type the starting address of the data
in the controller that receives the
message.
F. Choose Yes for Multihop.

Route a ControlNet Message

To send a message from a PLC-5C controller to a PLC-5C controller on a
different ControlNet network:
This section uses RSLogix 5 software, revision 3.x or
IMPORTANT
greater and PLC-5C Series C/Revision M,
Series D/Revision C, Series E/Revision B,
Series F/Revision A or greater
1. Open the RSLogix 5 project for the PLC-5 controller that sends the
message.
2. Display the set-up screen for the message.
3. Configure the General tab of the message instruction.
Peer-to-Peer Messaging
Publication CNET-UM001C-EN-P - November 2005
6-17