Table of Contents
Advertisement
What This Chapter Contains
Note the Power
Requirements
13Publication 1756-UM525A-EN-P - June 2003
Installing the 1756-HYD02 Module
This chapter describes how to install the 1756-HYD02 module.
For information about:
The 1756-HYD02 module mounts in a ControlLogix chassis and uses a
removable terminal block (RTB) to connect all field-side wiring.
Before you install your module, make sure you:
• install and ground a ControlLogix chassis and power supply.
• order and receive an RTB, and its components, for your application.
For more information on all the ControlLogix chassis and power supplies, see
the ControlLogix Selection Guide, publication 1756-SG001.
This module receives power from the 1756 chassis power supply and requires
two sources of power from the backplane:
• 700mA at 5.1V
• 2.5 mA at 24V
Add this current to the requirements of all other modules in this chassis to
prevent overloading the backplane power supply.
Chapter
See page:
14
15
16
23
26
28
29
2
13
Advertisement
Table of Contents
