Table of Contents
Advertisement
3.3 Starting up
3.3.1 Connecting
•
Connect T
F
SCN to the local area network by connecting the network adapter! Please, refer to section
RANS
ORM
3.2.3
Network!
•
If desired, connect a monitor to the DVI out connector of the T
Graphical
data.
•
Connect the T
F
RANS
ORM
•
Connect the graphic source to T
•
If you want to remotely control the host PC, connect the T
graphical source with the provided USB cable; please refer to sections
3.3.2 Switching on
Initial system start after delivery
The T
F
RANS
ORM
necting the T
For the configuration of the network properties please refer to
settings.
When power is applied to the T
is automatically switched on and initializes. When initialization is ready, the green LED software heartbeat [6]
starts blinking and the device is in operation mode.
The device is controlled via the T
interface.
If the host PC does not support DDC, then the output timing of the host PC has to be checked. It may not exceed
a resolution of UXGA (1600×1200), which is the maximal T
section
4.1.2 DDC
and
7.1 Technical
3.3.3 Switching off
To switch off the T
F
RANS
ORM
If TransForm SCN is switched off the graphical signal is also no longer looped through.
Therefore after switching off the TransForm SCN you should connect the monitor directly to
the host PC, to be able to see the graphical output!
Barco – TransForm SCN – R5976968 – Revision 01 – May 2006
SCN to the power net; please, refer to section
F
SCN; please refer to section
RANS
ORM
SCN is preconfigured at the factory with a default IP address. Therefore before con-
F
SCN to your company's network, its network settings have to be adapted.
RANS
ORM
F
SCN the green LED power OK [17] on its back is lighting and the device
RANS
ORM
F
SCN web interface; please refer to section
RANS
ORM
data.
SCN simply the power supply has to be disconnected.
________________________________________________________________________________________________
F
SCN, please refer to section
RANS
ORM
3.2.1 Power
supply!
3.2.2 Graphical
F
SCN and the computer who generates the
RANS
ORM
3.2.4 Remote
6.1 Initial configuration of the network
F
SCN input resolution. Please refer also to
RANS
ORM
3. Getting started
3.2.2
data.
Pointer!
4.3 TransForm SCN web
3-7
Advertisement
Table of Contents
