Auto Level; Auto Level Sequence - Lippert Components Ground Control 3.0 User Manual

Auto Level

1. After unhitching from tow vehicle and parking the tow vehicle
at a safe distance away from the trailer, press the "ON/OFF"
button (Fig. 22K) and then press "AUTO LEVEL" (Fig. 22F).
Note: Once the automatic leveling cycle has been started, it
is important that there is no movement in the trailer until the
trailer has completed the leveling process. Failure to remain
still during the leveling cycle could have an effect on the
performance of the leveling system.
Note: In order for Hitch Recognition feature to function, the auto
level sequence MUST be started with the front of the trailer
above level.

Auto Level Sequence

1. When Auto Level Sequence begins, the front of the trailer will
lower to a point near level.
2. Rear jacks will be grounded.
3. A side to side leveling sequence will occur.
Note: At this point on the 6-point system, the two middle jacks
will be grounded to stabilize the trailer. These two jacks do not
level the trailer.
4. Each jack will perform a final grounding touch.
5. LCD will read "AUTO LEVEL SUCCESS" (Fig. 24).
6. LCD will then read "READY Jacks: Down" (Fig. 25A), and
the green LED at the center of the four jack buttons will be
illuminated (Fig. 25B).
Note: If the AUTO LEVEL sequence does not perform as
described, place the system in manual mode and test that the
jacks operate correctly by pushing their coordinating buttons
on the touch pad; i.e. "FRONT" button operates only the front
jacks, etc.
lci1.com (574) 537-8900
Ground Control® 3.0
Aftermarket Manual
Fig.24
A
Fig.25
15
CCD-0001307
B
Rev: 04.19.18