Download Print this page

Advertisement

Double Size

Double-size effects
(Available for Insert Effects IFX2, 3, and 4)
090: Piano Body/Damper
(Piano Body/Damper Simulation)
This effect simulates the resonance of the piano sound board
caused by the string vibration, and also simulates the reso-
nance of other strings that are not being played when you
press the damper pedal. It will create a very realistic sound
when applied to acoustic piano sounds.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Piano
Body/Damper
Simulation
Right
D
-mod
Damper
Sound Board Depth
a
Sets the intensity of resonance of the sound board
Damper Depth
Sets the intensity of the string resonance created when the damper
pedal is pressed
b
Src
Selects the modulation source of damper effect
Tone
c
Sets tonal quality of effect sound
Mid Shape
d
Sets the mid range of tonal quality
Tune
e
Fine tuning
Wet/Dry
Sets the balance between the effect and dry sounds
Src
f
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
a: Sound Board Depth
This parameter sets the intensity of resonance of the piano sound
board.
b: Damper Depth, b: Src
This parameter sets the resonance intensity of the other strings
created when the damper pedal is pressed. The "Src" parameter
selects the modulation source from which the damper effect is
applied. Usually, select Damper #64 Pdl (Damper pedal).
The effect is off when a value for the modulation source
specified for the "Src" parameter is 63 or smaller, and the
effect is on when the value is 64 or higher.
c: Tone, d: Mid Shape
These parameters control the tonal quality of the effect sound.
e: Tune
Since this effect simulates the resonance of the strings, the sound
varies depending on the pitch. If you have changed tuning using
the Global P0 "Master Tune" (0–1a), adjust this parameter value.
200
091: St. Mltband Limiter
This is a stereo multiband limiter.
Stereo In - Stereo Out
Left
Right
a
Wet / Dry
b
c
d
e
Wet / Dry
f
g
0...100
0...100
,
h
Off...Tempo
1...100
0...36
i
–50...+50
Dry, 1:99...99:1, Wet
092: OD/HyperGain Wah
Off...Tempo
–100...+100
This distortion effect has two modes: overdrive and hyper-
gain that produces a strong distortion. A higher high-gain set-
ting is required for this effect relative to a normal-size effect.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
a
(Stereo Multiband Limiter)
Band-Pass Filters
Low
Envelope - Control
Mid
Envelope - Control
High
Envelope - Control
Envelope - Control
Low
Envelope - Control
Mid
Envelope - Control
High
Offset
Ratio
Sets the signal compression ratio
Threshold [dB]
Sets the level above which the compressor is applied
Attack
Sets the attack time
Release
Sets the release time
Low Offset [dB]
Sets the low range gain of trigger signal
Mid Offset [dB]
Sets the mid range gain of trigger signal
High Offset [dB]
Sets the high range gain of trigger signal
Gain Adjust [dB]
Sets the output gain
Src
Selects the modulation source for the output gain
Amt
Sets the modulation amount of the output gain
Wet/Dry
Sets the balance between the effect and dry sounds
Src
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
(Overdrive/Hyper Gain Wah)
Mode: Overdrive / Hyper-Gain
Drive
Pre Low-cut
4 Band PEQ
+
Wah
Driver
Output Level
Direct Mix
D
-mod
Wah
Switches Wah on/off
Src
Selects the modulation source that switches the Wah on and off
Sw
Selects the switching mode for the modulation source that switches
the Wah on and off
Wet / Dry
Limiter
Limiter
Gain Adjust
Limiter
Limiter
Gain Adjust
Limiter
Limiter
Wet / Dry
1.0:1...50.0:1, Inf:1
Fx:003
–40...0dB
Fx:003
1...100
Fx:003
1...100
Fx:003
–40...0dB
Fx:004
–40...0dB
Fx:004
–40...0dB
Fx:004
–Inf, –38...+24dB
Fx:003,
Off...Tempo
–63...+63
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Wet / Dry
Amp Simulation
Wet / Dry
Off, On
Fx:006,
Off...Tempo
Fx:006
Toggle, Moment
Fx:006

Advertisement

COMING SOON

   Also See for Korg TRITON proX

   Related Manuals for Korg TRITON proX

This manual also for:

Triton pro

Comments to this Manuals

Symbols: 0
Latest comments: