Connecting To A Controlling Host - R&S NRP18S Series User Manual

®
R&S NRP18S-xx
To disconnect the host interface of the power sensor
► Loosen the union nut of the screw-lock cable connector and remove the cable.

3.6 Connecting to a Controlling Host

As a controlling host, you can use:
●
Computer
●
Base Unit
For operating the power sensor, you can choose from various possibilities. For details,
see Chapter 5, "Operating
3.6.1 Computer
If the controlling host is a computer, you can operate the power sensor using a suppor-
ted software, the web user interface or remote control. For details, see
"Operating
► Establish the connection using:
●
3.6.1.1 Simple USB Connection
All R&S NRP18S-xx power sensors can be connected to the USB interface of a com-
puter.
Required equipment
●
R&S NRP18S-xx power sensor
●
R&S NRP‑ZKU cable
Setup
Figure 3-1: Setup with an R&S NRP
User Manual 1178.3686.02 ─ 05
Concepts",
Concepts", on page 18.
Host interface
See Chapter 3.6.1.1, "Simple USB
See Chapter 3.6.1.2, "R&S NRP‑Z5 Sensor Hub
on page 18.
Connection",
‑ ZKU cable
Preparing for Use
Connecting to a Controlling Host
Chapter 5,
on page 12.
Setup", on page 13.
7
12