R&S NRP18S Series User Manual page 71

®
R&S NRP18S-xx
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:CLEar
Clears the contents of the result buffer in continuous average mode.
Example:
Usage:
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:COUNt?
Queries the number of results that are currently stored in the result buffer. Available in
continuous average mode.
Example:
Usage:
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:DATA?
Queries the results of the continuous average result buffer and returns them even if the
buffer is not full.
In contrast,
the buffer is full.
Usage:
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:SIZE <count>
Sets the size of the result buffer in continuous average mode.
You can enable the buffer using
STATe.
Parameters:
<count>
Example:
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:STATe <state>
Enables or disables the buffered continuous average mode. If the buffer mode is
enabled, all results generated by trigger events are collected in the sensor until the buf-
fer is filled.
You can set the size of the buffer using
]BUFFer:SIZE.
User Manual 1178.3686.02 ─ 05
BUFF:CLE
Event
BUFF:COUN?
Query only
FETCh<Sensor>[:SCALar][:POWer][:AVG]?
Query only
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:
Range:
*RST:
BUFF:SIZE 1
See Chapter 9.3, "Performing a Buffered Continuous Average
Measurement",
Remote Control Commands
Configuring the Measurement Modes
1 to 8192
1
on page 123.
[SENSe<Sensor>:][POWer:][AVG:
returns a result only if
71