R&S NRP18S Series User Manual page 115

®
R&S NRP18S-xx
Usage:
SYSTem:SUTime <update_time>
Effective only in the NRP legacy mode.
Sets the status update time. That is the maximum rate in which the power sensor can
output measurement results. Relevant only in continuous measurement mode
(INITiate:CONTinuousON).
Parameters:
<update_time>
SYSTem:TLEVels?
Queries the possible power test levels of the sensor.
Usage:
SYSTem:TRANsaction:BEGin
Starts a series of settings.
Usage:
SYSTem:TRANsaction:END
Ends a series of settings.
Usage:
SYSTem[:SENSor]:NAME <sensorname>
Sets the name of the sensor according to your requirements. The specified name is
displayed in the web user interface of the network sensors.
The sensor name that you specify here is independent from the hostname of the sen-
sor. However, if the sensor name is not specified, it defaults to the hostname.
Example:
SYST:NAME "InputModule-X5"
Results in a display as shown in
User Manual 1178.3686.02 ─ 05
Query only
Range: 0.0 to 10.0
*RST: 10e-3
Default unit: Seconds
Query only
Event
Event
Figure 8-12.
Remote Control Commands
Configuring the System
115