R&S NRP18S Series User Manual page 102

®
R&S NRP18S-xx
CALibration:DATA
CALibration:DATA:LENGth?
CALibration:USER:DATA
CALibration:USER:DATA:LENGth?
CALibration<Channel>:ZERO:AUTO
CALibration:DATA <caldata>
Writes a binary calibration data set in the memory of the sensor.
Parameters:
<caldata>
CALibration:DATA:LENGth?
Queries the length in bytes of the calibration data set currently stored in the flash mem-
ory. Programs that read out the calibration data set can use this information to deter-
mine the capacity of the buffer memory required.
Example:
Usage:
CALibration:USER:DATA <caldata>
Transfers the user calibration data set, which mainly contains S-parameter sets for
user-specific devices. The query returns the data as it was downloaded to the power
sensor before.
After downloading of a new user calibration data set to the power sensor, the current
S-parameter correction settings become invalid. Safe operation of the power sensor is
only possible if the SELect and STATe commands are repeated after download. See
also:
●
[SENSe<Sensor>:]CORRection:SPDevice:STATe
●
[SENSe<Sensor>:]CORRection:SPDevice:SELect
Parameters:
<caldata>
CALibration:USER:DATA:LENGth?
Queries the length of the user calibration data block.
Usage:
User Manual 1178.3686.02 ─ 05
.......................................................................................................... 102
............................................................................................ 102
................................................................................................ 102
.................................................................................. 102
................................................................................103
<block_data>
CAL:DATA:LENG?
Query
57392
Response
Query only
<block_data>
Query only
Remote Control Commands
Calibrating/Zeroing the Power Sensor
102