System:parameters; System:parameters:delta; System:preset; System:reboot - R&S NRP18S Series User Manual

®
R&S NRP18S-xx
Use this query to determine a useful resolution for the result display near the lower
measurement limit.
Usage:

SYSTem:PARameters?

Lists all commands with default values, limits and ranges.
Usage:

SYSTem:PARameters:DELTa?

Lists all commands that differ from the defined default status set by
The commands are output with default values, limits and ranges.
Usage:

SYSTem:PRESet

Triggers a sensor reset.
The command essentially corresponds to the *RST command, with the exception that
the settings of the following commands are persistently held:
INITiate:CONTinuous
SENSe:AVERage:TCONtrol
SENSe:TRACe:AVERage:TCONtrol
Usage:

SYSTem:REBoot

Reboots the sensor.
Usage:

SYSTem:RESTart

Restarts the firmware of the R&S NRP18S-xx.
Usage:
SYSTem:RUTime <update_time>
Effective only in the NRP legacy mode.
Sets the result update time. That is the maximum rate in which the power sensor can
output measurement results. Relevant only in continuous measurement mode
(INITiate:CONTinuous
User Manual 1178.3686.02 ─ 05
Query only
Query only
Query only
Event
Event
Event
ON).
Remote Control Commands
Configuring the System
on page 45.
*RST
113