Table of Contents
Advertisement
®
R&S
NRQ6
Carefully loosen the union nut at the front of the RF connector of the
R&S NRQ6.
2. Remove the R&S NRQ6.
3.5
Connecting to a power supply
The power for the R&S NRQ6 is supplied over the LAN PoE+ interface. See also
Chapter 4.3, "LAN PoE+
Choose the PoE+ power sourcing equipment (PSE) with care
Only use PoE+ power sourcing equipment (PSE) as specified in the IEEE 802.3at
standard. Otherwise, the following can happen:
● If too much power is supplied, the R&S NRQ6 can get overheated and
become damaged as a result.
● If the supplied power is not sufficient, the R&S NRQ6 does not work properly
or not at all.
To connect to a LAN PoE+ interface
1. Use a suitable cable as described in
on page 32.
2. Connect one end of the cable to the LAN interface of the R&S NRQ6.
3. Connect the other end of the cable to one of the following:
● PoE+ port of a LAN switch:
See
Chapter 3.6.1.1, "Setup with a PoE+ ethernet
● Output of a PoE+ injector:
See
Chapter 3.6.1.2, "Setup with a PoE+ injector and a non-PoE+ ethernet
switch",
on page 21.
See
Chapter 3.6.1.3, "Setup with a PoE+
3.6
Connecting to a controlling host
For operating the R&S NRQ6, you can choose from various possibilities. For
details, see
Chapter 5, "Operating
Getting Started 1178.3705.02 ─ 08
interface",
on page 32.
Chapter 4.3, "LAN PoE+
concepts",
Connecting to a controlling host
switch",
injector",
on page 22.
on page 37.
Preparing for use
interface",
on page 20.
18
Advertisement
Table of Contents
