R&S NRP18S Series User Manual page 77

®
R&S NRP18S-xx
See also
Parameters:
<mode>
Example:
[SENSe<Sensor>:]TRACe:AVERage[:STATe] <state>
Switches the averaging filter on and off for the Trace mode.
Parameters:
<state>
[SENSe<Sensor>:]TRACe:DATA?
Returns the measured trace data in a well-defined format.
Unlike the FETCh? command, [SENSe<Sensor>:]TRACe:DATA takes the settings of
[SENSe<Sensor>:]AUXiliary into account, as explained below.
Command response
To describe the format of the command response, it is important to know some addi-
tional information.
Besides the average power, the sensor can measure additional measurands like mini-
mum, maximum or random. These additional measurands are denoted as auxiliary
measurands and can be selected through the [SENSe<Sensor>:]AUXiliary com-
mand.
A trace measurement can be configured to deliver up to three measurands. Therefore,
the resulting block of data which is provided by a [SENSe<Sensor>:]TRACe:DATA
query can contain 1 to 3 blocks of user data.
Basically, the
Arbitrary Block Response Data as defined in IEEE488.2. This object consists of a
header and some content.
User Manual 1178.3686.02 ─ 05
Chapter 8.5, "Controlling the
MOVing | REPeat
MOVing
Outputs intermediate values to facilitate early detection of
changes in the measured quantity. In the settled state, that
means when the number of measurements specified by the
average count has been performed, a moving average is output.
REPeat
Specifies that a measurement result is not output until the entire
measurement has been completed. This means that the number
of measurement cycle repetitions is equal to the set average
count. If the average count is large, the measurement time can
be very long.
The average count is set using
AVERage:COUNt.
*RST:
TRAC:AVER:TCON REP
*RST:
[SENSe<Sensor>:]AUXiliary
Remote Control Commands
Configuring the Measurement Modes
Measurement", on page 49.
[SENSe<Sensor>:]TRACe:
REPeat
ON
response represents a Definite Length
77