R&S NRP18S Series User Manual page 75

®
R&S NRP18S-xx
[SENSe<Sensor>:]TIMing:EXCLude:STARt
EXCLude:STOP, see
Remote commands:
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:COUNt
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:WIDTh
[SENSe<Sensor>:][POWer:]TSLot[:AVG][:EXCLude]:MID:OFFSet[:TIME]
[SENSe<Sensor>:][POWer:]TSLot[:AVG][:EXCLude]:MID:TIME
[SENSe<Sensor>:][POWer:]TSLot[:AVG][:EXCLude]:MID[:STATe]
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:COUNt <count>
Sets the number of simultaneously measured timeslots in the timeslot mode (see
ure 8-3).
Parameters:
<count>
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:WIDTh <width>
Sets the length of the timeslot (see
Parameters:
<width>
[SENSe<Sensor>:][POWer:]TSLot[:AVG][:EXCLude]:MID:OFFSet[:TIME] <time>
Determines the distance from the start of the timeslots to the start of the interval to be
blanked out (see
Parameters:
<time>
[SENSe<Sensor>:][POWer:]TSLot[:AVG][:EXCLude]:MID:TIME <time>
Sets the length of the time interval in the timeslots to be excluded from the measure-
ment (see
Note: Even if the exclusion interval exceeds the timeslot because, for example, its right
limit is outside the timeslot, correct results are obtained. In the extreme case, where
the interval length has been set to a value greater than the timeslot length, 0 W is out-
put as the measured power. No error message is output.
User Manual 1178.3686.02 ─ 05
Chapter 8.8.3, "Setting Exclusion
Range:
*RST:
Range:
*RST:
Default unit: Seconds
Figure 8-3).
Range:
*RST:
Default unit: Seconds
Figure 8-3). The parameter applies to each individual timeslot.
Remote Control Commands
Configuring the Measurement Modes
and
[SENSe<Sensor>:]TIMing:
Time",
................................................................ 75
.................................................................75
............................................75
1 to 128
8
Figure 8-3).
10.0e-6 to 0.10
1.000e-3
0.00 to 0.10
0.00
on page 85.
..............................75
........................................ 76
Fig-
75