R&S NRP18S Series User Manual page 83

®
R&S NRP18S-xx
[SENSe<Sensor>:]AVERage:COUNt:AUTO:RESolution <resolution>
Defines the number of significant places for linear units and the number of decimal pla-
ces for logarithmic units which should be free of noise in the measurement result.
The setting is only taken into account, if
ON and
Parameters:
<resolution>
[SENSe<Sensor>:]AVERage:COUNt:AUTO:SLOT <slot>
Available only if
Sets a timeslot from which the measured value is used to determine the filter length
automatically. The timeslot number must not exceed the number of the currently set
timeslots.
Parameters:
<slot>
[SENSe<Sensor>:]AVERage:RESet
Deletes all previous measurement results that the averaging filter contains and initial-
izes the averaging filter. The filter length gradually increases from 1 to the set averag-
ing factor. Thus, trends in the measurement result become quickly apparent. Note that
the measurement time required for the averaging filter to settle completely remains
unchanged.
Use this command if:
●
High averaging factor is set.
[SENSe<Sensor>:]AVERage:COUNt
●
Intermediate values are output as measurement results.
[SENSe<Sensor>:]AVERage:TCONtrol
●
Power has significantly decreased since the previous measurement, for example
by several powers of 10.
In this situation, previous measurement results, which are still contained in the averag-
ing filter, strongly affect the settling of the display. As a result, the advantage of detect-
ing trends in the measurement result while the measurement is still in progress is lost.
Example:
Usage:
User Manual 1178.3686.02 ─ 05
[SENSe<Sensor>:]AVERage:COUNt:AUTO:TYPE
Range:
*RST:
[SENSe<Sensor>:]FUNCtion
Range:
*RST:
AVER:RES
Event
Remote Control Commands
Configuring Basic Measurement Parameters
[SENSe<Sensor>:]AVERage:COUNt:AUTO
1 to 4
3
is set to POWer:TSLot:AVG.
1 to 128
1
MOVing
RES are set.
83