R&S NRP18S Series User Manual page 15

®
R&S NRP18S-xx
a) Connect the R&S NRP‑ZK6 cable to the power sensor.
b) Connect the power sensors to the R&S NRP‑Z5 sensor hub. You can connect
c) Connect the R&S NRP‑Z5 to the computer.
d) Connect the power sensors to the signal source.
e) Connect the delivered external power supply unit to the R&S NRP‑Z5 and to an
f)
g) Connect the trigger output of the R&S NRP‑Z5 with a BNC cable to the trigger
2. On the computer, start a software application to view the measurement results.
See
3.6.2 Base Unit
As a controlling host, you can use an R&S NRX or R&S NRP2 base unit. You can also
operate the power sensor using other supported Rohde & Schwarz instruments with a
sensor connector. For details, see also the user manual of the instrument.
► Establish the connection with the base unit using:
●
User Manual 1178.3686.02 ─ 05
See "To connect a cable to the host interface of the power sensor"
up to four sensors.
AC supply connector.
Connect the trigger input of the R&S NRP‑Z5 with a BNC cable to the trigger
source (optional).
device (optional).
Chapter 5, "Operating
Host interface
See Chapter 5.6, "R&S
See Chapter 5.7, "R&S
Connecting to a Controlling Host
Concepts", on page 18.
NRX", on page 29
NRP2", on page 31
Preparing for Use
on page 11
15