R&S NRP18S Series User Manual page 89

®
R&S NRP18S-xx
Figure 8-7: Operation with 2-port device between signal source and sensor input
Configuring the S-Parameter Correction
[SENSe<Sensor>:]CORRection:SPDevice:LIST?
[SENSe<Sensor>:]CORRection:SPDevice:SELect
[SENSe<Sensor>:]CORRection:SPDevice:STATe
[SENSe<Sensor>:]CORRection:SPDevice:LIST?
Queries the list of the S-parameter data sets that have been downloaded to the power
sensor. The result of the query indicates the consecutive number and mnemonic of
each data set.
Usage:
[SENSe<Sensor>:]CORRection:SPDevice:SELect <num>
Selects a downloaded data set for S-parameter correction.
See also
Parameters:
<num>
Manual operation:
[SENSe<Sensor>:]CORRection:SPDevice:STATe <state>
Activates or deactivates the S-parameter correction. If activated, uses the S-parameter
data set selected by [SENSe<Sensor>:]CORRection:SPDevice:SELect.
See also
Parameters:
<state>
Example:
Manual operation:
User Manual 1178.3686.02 ─ 05
Query only
Chapter 8.8.4.3, "S-Parameter
Range:
*RST:
See "S-Parameter Device Locked"
Chapter 8.8.4.3, "S-Parameter
*RST:
CORR:SPD:SEL 1
Selects an S-parameter correction data set.
CORR:SPD:STAT ON
Activates the S-parameter correction.
See "S-Parameter Correction State Locked"
Remote Control Commands
Configuring Basic Measurement Parameters
3-Path Diode Power Sensor
MHz to GHz, 100 pW to 200 mW (−70 dBm to +23 dBm)
SMART SENSOR TECHNOLOGY
................................................................ 89
.............................................................. 89
............................................................... 89
Correction", on page 87.
1 to 1999
1; can differ if a calibration set defines another
value.
on page 94
Correction", on page 87.
OFF; can differ if a calibration set defines another
value.
NRP
on page 94
89