Removing The Rear Cover - Christie GS Series Service Manual

5. Flip the projector back over.
6. Slide the top cover towards the front of the projector and lift it.
7. Unplug one connector to remove the top cover module.
8. Remove the LED board.
See Replacing the LED board
9. Remove the front IR sensor board.
See Replacing the front IR sensor board
10. Transfer the LED board and the front IR sensor board to the new top cover.
11. If required, replace the top cover.
12. To re-install the top cover, follow these steps in reverse order.

Removing the rear cover

The rear cover including warning label, spec label and other printing.
1. Remove the top cover.
See Removing the top cover
2. On the I/O cover, remove the eight hex screws with a M3 socket driver.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
on page 73.
on page 73.
on page 51.
Projector covers and feet
52