Dimensions; To Install The Mate3; Figure 2 Mate3 Dimensions - Alpha Group OutBack Power MATE3 Owner's Manual

Dimensions

To Install the MATE3

1. Install all other OutBack components first.
2. Locate the position for the MATE3. Allow room (approximately 2-3") on the right side of the MATE for
the SD Card to be inserted or removed.
3. Run the CAT5 cable from the source (HUB, inverter, or charge controller) to the MATE3's location.
Connect the CAT5 cable to the source, but not to the MATE3.
4. Power up each OutBack device connected directly or indirectly (through the HUB) to the MATE3.
5. Then connect the CAT5 cable to the port on the MATE3.
6. Secure the MATE3 to the mounting surface or mounting bracket, if present.:
 If a mounting bracket is used, install the mounting bracket using the instructions supplied with
the bracket.
 If a mounting bracket is not used, use the dimensions above to mark four holes in the wall. Drill
leader holes, then run the screws through the mounting holes into the wall surface.
16
Figure 2 MATE3 Dimensions
SD Card
Slot
Front
Cover
Mounting
Holes (x4)
Installation
900-0117-01-00 Rev A