Reset To Factory Defaults - Alpha Group OutBack Power MATE3 Owner's Manual

Reset to Factory Defaults

This menu allows the user to erase all settings from the selected charge controller and start over with the
values programmed at the factory. These values are listed in the charge controller User's Manual.
To access the Reset to Factory Defaults menu:
1. Access the Charge Controller menu as shown in Figure 90 on page 94.
2. Use the control wheel to highlight the Reset to Factory Defaults menu.
Press the button in the center of the control wheel to accept the selection.
3. Use the soft keys below the LCD to select No or Yes.
~ If <No> is selected, the screen returns to the Charge Controller menu. No changes will be made
to any settings.
~ If <Yes> is selected, the inverter's settings will immediately change to the original factory values.
The screen will display the message Charge Controller Restored to Factory
A <Continue> soft key will appear. Pressing this key will return the screen to the
Charge Controller menu.
4. After setting the parameters for each set point, press the TOP navigation key to return to the
Main Menu screen.
Figure 105
900-0117-01-00 Rev A
Resetting Factory Default Settings on the Charge Controller
Charge Controller Settings
Defaults.
105