Alpha Group OutBack Power MATE3 Owner's Manual page 123

AGS Must Run Schedule
Must Run Schedule time is a daily time period when the MATE3 commands the generator to run. This is
usually set because large loads are expected to be present. Must Run Schedule times can be set
individually for weekdays and weekends.
Setting start and stop times to the same time disables the Must Run Schedule function.
To enable the MATE3 to start the generator based on the
1. Access the MATE menu as shown in Figure 113.
2. Use the control wheel to select the Advanced Generator Start menu option.
Press the button in the center of the control wheel to accept the selection.
3. Use the control wheel to highlight Must Run Schedule.
Press the button in the center of the control wheel to select the menu item.
4. Use the control wheel to select N for no (disabled) or Y for yes (enabled).
5. Use the control wheel to increase or decrease the Weekday Start time.
Press the button in the center of the control wheel to select the set point.
6. Use the control wheel to increase or decrease the Weekday Stop time.
Press the button in the center of the control wheel to select the set point.
7. Use the control wheel to increase or decrease the Weekend Start time.
Press the button in the center of the control wheel to select the set point.
8. Use the control wheel to increase or decrease the Weekend Stop time.
Press the button in the center of the control wheel to select the set point.
9. Press the TOP navigation key to return to the Main Menu screen.
Figure 120
900-0117-01-00 Rev A
MATE/AGS/Must Run Schedule Screen
MATE3 Settings
Must Run Schedule
:
Set points:
 Enable: N = No, Y = Yes
 Weekday Start: 00:00 to 23:59
 Weekday Stop: 00:00 to 23:59
 Weekend Start: 00:00 to 23:59
 Weekend Stop: 00:00 to 23:59
121