Reset To Factory Defaults - Alpha Group OutBack Power MATE3 Owner's Manual

Reset to Factory Defaults

This menu allows the user to erase all settings from the selected inverter and start over with the values
programmed at the factory. These values are listed in the inverter Operator's Manual.
To access the Reset to Factory Defaults menu:
1. Access the Inverter menu as shown in Figure 71 on page 75.
2. Use the control wheel to highlight the Reset to Factory Defaults menu.
Press the button in the center of the control wheel to accept the selection.
3. Use the soft keys below the LCD to select No or Yes.
~ If <No> is selected, the screen returns to the Inverter menu.
No changes will be made to any settings.
~ If <Yes> is selected, the inverter's settings will immediately change to the original factory values.
The screen will display the message Inverter Restored to Factory Defaults. A <Continue> soft
key will appear. Pressing this key will return the screen to the Inverter Menu.
4. After setting the parameters for each set point, press the TOP navigation key to return to the
Main Menu screen.
Figure 89
900-0117-01-00 Rev A
Resetting Factory Default Settings on the Inverter
Inverter Settings
93