General Safety; Personal Safety - Alpha Group OutBack Power MATE3 Owner's Manual

General Safety

Personal Safety

900-0117-01-00 Rev A
WARNING: Limitations on Use
This equipment is NOT intended for use with life support equipment or other
medical equipment or devices.
CAUTION: Equipment Damage
Only use components or accessories recommended or sold by OutBack Power
Technologies or its authorized agents.
IMPORTANT:
Do not attempt to install this equipment if it appears to be damaged in any
way. See the Troubleshooting Section for instructions on how to return the
equipment if you know, or suspect, it is damaged.
WARNING: Personal Injury

Use standard safety practices when working with electrical equipment
(e.g., remove all jewelry, use insulated tools, wear cotton clothing, etc.)

Review the system configuration to identify all possible sources of energy. Ensure
ALL sources of power are disconnected before performing any installation or
maintenance on this equipment. Confirm that the terminals are de-energized
using a validated voltmeter (rated for a minimum 1000 Vac and 1000 Vdc) to verify
the de-energized condition.
WARNING: Fire Hazard
Do not operate the unit with damaged or substandard cabling.
CAUTION: Equipment Damage

Strictly enforce clearance requirements and keep all vents clear of obstructions that
can inhibit air flow around or through the unit.

Sensitive electronics inside the equipment can be destroyed by static electricity.
Be sure to discharge any static electricity built up before touching the equipment
and wear appropriate protective gear.

Do not perform any servicing other than that specified in the installation
instructions unless qualified to do so and have been instructed to do so by OutBack
Power Technologies Technical Support personnel.
Important Safety Instructions
3