Relay Set Points - Alpha Group OutBack Power MATE3 Owner's Manual

Relay Set Points

This menu allows the user to adjust the criteria used by the Auto selection in the Relay Mode menu. For
more information on these criteria, see the User's Manual for the battery monitor.
To access the Relay Set Points menu:
1. Access the Battery Monitor menu as shown in Figure 106.
2. Use the control wheel to highlight the Relay Set Points menu.
Press the button in the center of the control wheel to accept the selection.
3. Use the control wheel to increase or decrease the set points to the correct voltage.
Press the button in the center of the control wheel to accept the selection.
This should automatically move the highlighting to the next set point.
4. After setting the parameters for each set point, press the TOP navigation key to return to the
Main Menu screen.
Set Points:
The following set points assume N.O. logic. If N.C. logic is used, all use of the words "close" or "open" are
reversed.
 Voltage: High: The relay will close upon reaching a specified high voltage level (following the
appropriate delay; see below).
 (Voltage) Low: After the relay was closed according to the High voltage set point, it will open again
upon reaching a specified low voltage level (following the appropriate delay; see below).
 SOC: High: If voltage conditions are not met, the relay will close when the battery state of charge
(SOC) increases to a specified percentage (following the appropriate delay; see below).
 (SOC) Low: After the relay was closed according to the High SOC set point, it will open again upon
reaching a specified low SOC level (following the appropriate delay; see below).
 Delay: High: Sets the delay time before the relay closes due to a High set point. This applies to either
the SOC or voltage settings.
 (Delay) Low: Sets the delay time before the relay opens due to a Low set point. This applies to either
the SOC or voltage settings.
110
Figure 110 Relay Set Points
Battery Monitor Settings
900-0117-01-00 Rev A