Alpha Group OutBack Power MATE3 Owner's Manual page 74

Set User Access Level
This feature is not implemented at this time.
The Set User Access Level menu allows four different levels of user access to set points for programming.
A user who enters the standard password ( 141) will only have access to the menus permitted by this
setting.
Set User Access Level
To access the
1. Access the System Settings menu as shown in Figure 59.
2. Access the Installer Settings menu as shown in Figure 67.
3. Use the control wheel to highlight the Set User Access Level menu.
Press the button in the center of the control wheel to accept the selection.
4. Use the control wheel to change the value of the set point to Full, Advanced, Basic, or Minimum.
Press the button in the center of the control wheel to accept the selection.
5. After setting the parameters for each set point, press the TOP navigation key to return to the
Main Menu screen.
Set Points:
 Full - (TBD)
 Advanced - (TBD)
 Basic – (TBD)
 Minimum – (TBD)
72
menu:
Figure 68 Set User Access Level
Inverter Settings
900-0117-01-00 Rev A