AGS Quiet Time Schedule
Quiet Time is a period of time when the generator should not run, due to the risk of inappropriate noise or
other reasons.
Setting start and stop times to the same time disables the Quiet Time function.
The Quiet Time settings overrides most of the "starting" set points (e.g., Voltage, Load, Must Run, Exercise
etc.), preventing the generator from starting automatically. The only exception is the 2 Minute Start
under Voltage Start, which is considered an "emergency" start set point and which will start the generator
regardless of Quiet Time settings.
To enable the MATE3 to start the generator based on the
1. Access the MATE menu as shown in Figure 113.
2. Use the control wheel to select the Advanced Generator Start menu option.
Press the button in the center of the control wheel to accept the selection.
3. Use the control wheel to highlight Quiet Time Schedule.
Press the button in the center of the control wheel to select the menu item.
4. Use the control wheel to select N for no (disabled) or Y for yes (enabled).
Press the button in the center of the control wheel to select the set point.
5. Use the control wheel to increase or decrease the Weekday Start time.
Press the button in the center of the control wheel to select the set point.
6. Use the control wheel to increase or decrease the Weekday Stop time.
Press the button in the center of the control wheel to select the set point.
7. Use the control wheel to increase or decrease the Weekend Start time.
Press the button in the center of the control wheel to select the set point.
8. Use the control wheel to increase or decrease the Weekend Stop time.
Press the button in the center of the control wheel to select the set point.
9. Press the TOP navigation key to return to the Main Menu screen.
Figure 121
122
MATE/AGS/Quiet Time Schedule Screen
MATE3 Settings
Quiet Time Schedule
:
Set points:
Enable: N = No, Y = Yes
Weekday Start: x0:00
Weekday Stop: x0:00
Weekend Start: x0:00
Weekend Stop: x0:00
900-0117-01-00 Rev A
Need help?
Do you have a question about the OutBack Power MATE3 and is the answer not in the manual?