Pharmacia Biotech Multiphor II User Manual page 89

9. Multiphor II application kits and accessories
Before disassembling the mould, carefully remove any unpolymerized gel
solution. Remove the weight, the holding guides and the black end screw.
To remove the gel, insert a spatula under the gel spacer and between the film
and the long glass plate and twist slightly to separate them. This introduces
air between the gel and the short glass plate and allows the plate to be
removed without disturbing the gel surface.
Holding the gel spacer at one corner, carefully peel it away. Remove the
prepared gel from the Gel Casting Table. The gel may be used immediately
or covered with a thin polyester film and stored in a sealed plastic bag at
4 °C for several days.
Wash the Gel Casting Table and accessories with a mild detergent and rinse
well with water before using again.
82
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com