Pharmacia Biotech Multiphor II User Manual page 74

Optional accessories
Designation
Roller
GelBond film, 124x258 mm (50/pkg)
Sample Application Syringe, 15 µl
EPH/IEF Sample Application Foil,
24 samples 2-4 µl (5/pkg)
Humidity Chamber 125x260 mm (4/pkg)
The 3 mm thick glass plate is used as a support for GelBond film. Clean the
glass plate with a mild detergent. Rinse it with distilled water and dry.
Pour a few ml of water on to the 3 mm thick glass plate and lay the film
over it with the hydrophilic side up (see Instructions supplied with the film).
Centre the film over the glass plate. Beginning at one end, use the roller to
apply an even pressure over the film surface in order to eliminate air bubbles
and seal the film to the plate with a minimum of water. Remove any excess
water with a tissue.
Position the glass plate with spacer on top of the film, leaving 1 cm free at
both ends. Hold the plates securely together by placing one FlexiClamp on
each of the long sides. Place the mould in a heating cabinet at 70 °C for 10
minutes.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
9. Multiphor II application kits and accessories
Code No.
80-1106-79
80-1129-32
80-1106-48
80-1129-47
18-1016-78
67