Kenwood NX-5000 Series Function Reference page 92

1 DMR CONVENTIONAL SYSTEM
1.18 Remote Operation by Radio Communication (Remote Control)
Sending a Remote Control Message in Remote Control Mode
Various Remote Control messages can be sent in Remote Control Mode.
Operating the transceiver
0
Initiating an Individual Call by list selection
1
Press the DMR Remote Control
The transceiver enters Remote Control Mode and then the Unit ID selection display will appear.
The following operations are identical even if the transceiver enters Remote Control Mode by pressing the Menu
key.
2
Press the [ ] or [
Refer to Common FUNC
selection methods.
3
Press the Menu ([
The selection display of the options menu appears.
4
Press the [ ] or [
Stun: A Remote Stun message is sent.
Revive: A Remote Revive message is sent.
Kill: A Remote Kill message is sent.
Monitor: A Remote Monitor message is sent.
Radio Check: A Radio Check message is sent.
5
Press the PTT switch, the
The selected Remote Control message is sent.
DMR FUNC (K, F)/Ver 2.20
key.
] key to select a Unit ID from the Individual ID List.
"Selecting or Clearing Data from a
]) or [ ]key.
] key to select the Remote Control message to send.
Menu ([ ]) key, or the
List" for
[ ] key.
CONTENTS
A
12 : 34
M
Remote Control 002
TRUCK 824
TRUCK 825
TRUCK 826
N ex t Bac k
A
12 : 34
M
Remote Control 1
Stun
Revive
Kill
Se nd Bac k
A
12 : 34
M
Remote Control 5
Kill
Monitor
Radio Check
Se nd Bac k
75
INDEX