Kenwood NX-5000 Series Function Reference page 160

4 SCAN
4.4 Scanning All Target Zones for Scanning (Multi-Zone Scan)
If Selected Channel Scan is enabled, the selected channel can be scanned even if the channel is excluded from the
0
target channels for scan. (Refer to
For Portable, if the transceiver changes the zone during Multi-Zone Scan by using the Selector with "Zone Select"
0
configured and if the new zone is not configured, the "
If another zone is selected during the Multi-Zone Scan, the transceiver starts the scan according to the configuration in
0
Scan Type of the selected zone.
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Configuring Scan Add to be enabled or disabled (
Conventional > General)
0
Configuring Zone Add to be enabled or disabled (
0
Configuring Scan Type (
0
Configuring "Scan" Displayed to be enabled or disabled (
General)
Conditions to Activate the Scan (Multi-Zone Scan)
One of the following conditions must be satisfied for the transceiver to start the Multi-Zone Scan:
0 When a total of two or more channels targeted to be scanned exists in the zone targeted to be scanned
0
When only one target zone exists, and when one target channel exists in the target zone and a Priority Channel exists
in the target zone or another zone
0
When Priority Channel 1 and Priority Channel 2 exist in another zone, even if no zone to be scanned exists
Conditions to Resume the Scan (Multi-Zone Scan)
One of the following conditions must be satisfied to resume the Multi-Zone Scan while the transceiver pauses the scan:
0 When a total of two or more channels targeted to be scanned exists in the zone targeted to be scanned
0
When only one target zone exists, and when one target channel exists in the target zone and a Priority Channel exists
in the target zone or another zone
0 When Priority Channel 1 and Priority Channel 2 exist in another zone, even if no zone to be scanned exists
If the transceiver does not satisfy the conditions to resume the scan, the scan remains paused.
Transceiver Behavior in the Case that the Scan Cannot Be Resumed (Multi-Zone
Scan)
If the transceiver manually switches during the scan to the zone or channel which does not satisfy the condition to resume
the scan, the transceiver displays the selected channel and the scan remains paused.
If the PTT switch is pressed while the condition to resume the scan is not satisfied, the transceiver transmits using the
Revert Channel. Upon elapse of the time configured in Dwell Time after completion of the transmission, the transceiver
reverts to the selected channel, and the scan does not resume.
DMR FUNC (K, F)/Ver 2.20
Selected Channel Scan.)
" icon blinks and the scan pauses.
Transceiver Settings > Zone/Channel > Channel Edit > DMR
Transceiver Settings > Zone/Channel > Zone Edit > Scan)
Transceiver Settings > Zone/Channel > Zone Edit > Scan)
Transceiver Settings > Key Assignment)
Transceiver Settings > Scan > Scan Information >
CONTENTS
143
INDEX