Kenwood NX-5000 Series Function Reference page 23

1 DMR CONVENTIONAL SYSTEM
1.1 Initiating Voice Communications (Basic Transmission and Reception)
TOT Reset Time
TOT Reset Time is the time required to initialize and reset the elapsed time for Time-out Timer.
Example 1: Time-out Timer: 30 sec, TOT Reset Time: 10 sec
The transceiver considers a retransmission within this configured length of time as a continuous transmission. In the following
example, the counting of Time-out Timer continues because the transmission was started by a user pressing the PTT
switch while the TOT Reset Time was counting down.
Example 2: Time-out Timer: 30 sec, TOT Reset Time: 10 sec
Note
If "Off" is configured for TOT Reset Time, the Time-out Timer will be reset immediately after the transceiver finishes
0
transmitting.
The timer will be reset if the zone or channel is changed while the TOT Rekey Time is counting down.
0
Configuration using KPG-D1/ D1N
Configuring various functions of Time-out Timer (
Conventional > General > Time-out Timer)
DMR FUNC (K, F)/Ver 2.20
PTT
Press Release
Transceiver
Transmit Receive
TOT Count Start
TOT Reset Time
TOT Reset Time
Count Start
Time 0 sec 10 sec
Figure 1-4 TOT Reset Time 1
PTT
Press
Transceiver
Transmit
TOT Count Start
TOT Reset Time
Count Start
Time 0 sec 10 sec
Figure 1-5 TOT Reset Time 2
Press
Transmit
TOT Reset
Count Start
Expire
20 sec 25 sec 30 sec 55 sec
Release Press
Receive Transmit
Expire TOT
TOT Reset Time
Reset
20 sec 30 sec
Transceiver Settings > Personal > Personal Features > DMR
CONTENTS
Expire TOT
INDEX
6