Kenwood NX-5000 Series Function Reference page 48

1 DMR CONVENTIONAL SYSTEM
1.7 Making a Group Call
3
Press the PTT switch.
The transceiver initiates a Group Call.
If Group Call Mode has been entered with "Group + Status" or "Group + Short Message", Status Mode or Short
Message Mode is entered by pressing the [F] key.
Note
The selection screen for the Group ID List closes at the same time as pressing the PTT switch. If selecting an ID and
0
sending a Group Call again, reexecute the operations from step 1.
If Transmit LED is enabled, the LED lights red when the transceiver is transmitting. (Refer to Common FUNC
0
LED.)
If PTT Proceed Tone is enabled, a Proceed Tone (3 beeps) sounds from the transceiver when the transceiver becomes
0
ready for communications after the PTT switch is pressed. (Refer to Common FUNC
to Start Communications (PTT Proceed
The transceiver starts a Group Call only by a user pressing the PTT switch if the transceiver transmits on a channel with
0
"Group Call" configured for Selcall on PTT. In this case, a Group ID does not need to be selected by using the transceiver.
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Configuring Selcall on PTT (Personality) (
> DMR > Selcall on PTT)
0
Configuring Selcall on PTT (Channel Edit) (
Conventional > DMR > Selcall on PTT)
Receiving a Group Call
If the received Group ID matches the Group ID configured for the transceiver, the transceiver can receive the Group Call.
Transceiver behavior
1
The transceiver receives a Group Call.
The " " icon blinks and a received Group ID appears. If Unit ID Display
on Group Call is enabled, the ID Name of the transmitting transceiver is
displayed. (Refer to
(Unit ID Display on Group
2
Press the PTT switch.
The transceiver can respond to the received Group ID. When a key other than the PTT switch is pressed, the
configured function will be activated.
DMR FUNC (K, F)/Ver 2.20
Tone).)
Transceiver Settings > Personal > Personality > DMR Conventional
Display When the Transceiver Receives a Group Call
Call).)
Transceiver Settings > Key Assignment)
Transceiver Settings > Zone/Channel > Channel Edit > DMR
Using Sound to Notify the Timing
G r o u p
S Q U A D 0 3
O F F I C E
M en u Zo ne+
CONTENTS INDEX
Transmit
A
12 : 34
M
31