Kenwood NX-5000 Series Function Reference page 34

1 DMR CONVENTIONAL SYSTEM
1.5 Making an Individual Call
1.5 Making an Individual Call
Individual Call can be used to initiate a call to a target transceiver individually to establish voice calls.
By specifying a Unit ID, the transceiver can initiate a call to the transceiver having the Unit ID.
Initiating an Individual Call
An Individual Call can be started by one of the following methods.
0
Individual Call Mode
In Individual Call Mode, an Individual Call is initiated by selecting a Unit ID configured in the Individual ID List or directly
entering a Unit ID.
Pressing the Individual, Individual + Status, or Individual + Short Message key places the transceiver in Individual
Call Mode.
The transceiver also enters Individual Call Mode by selecting "Individual", "Individual + Status", or "Individual + Short
Message" after the transceiver enters Menu Mode by pressing the Menu key. (Refer to Common FUNC
Mode.)
If "Individual", "Individual + Status", or "Individual + Short Message" is configured in Keypad Operation, pressing the [0]
to [9] keys on the keypad also places the transceiver in Individual Call Mode. The transceiver enters Unit ID Shortcut
Entry Mode or will be on hold as the first digit of the Unit ID is entered.
(Refer to Common FUNC
0
Selcall on PTT
The transceiver initiates an Individual Call when the PTT switch is pressed on a channel where "Individual Call" is
configured for Selcall on PTT. The Unit ID of the target transceiver can be configured by selecting one Unit ID from the
Individual ID List by using KPG-D1/ D1N.
0
Talkback
By pressing the PTT switch while the Auto Reset Timer is counting down after the transceiver receives an Individual
Call, the transceiver can respond (Talkback) to the transceiver which made the Individual Call.
0
Stack Mode
Selecting the receive history in Stack Mode and pressing the PTT switch initiates an Individual Call. (Refer to Common
FUNC Viewing the Receive History
0
PC command
The transceiver starts an Individual Call upon the receipt of a PC command from the communication port. To use a PC
command, "Data" or "Data + GPS Data Output" needs to be assigned to the communication port of the transceiver. (Refer
to Common FUNC Available Functions for COM
DMR FUNC (K, F)/Ver 2.20
Keypad Operation.)
(Stack).)
Port.)
Using Menu
CONTENTS INDEX
17