Kenwood NX-5000 Series Function Reference page 154

4 SCAN
4.3 Scan by Registering Multiple Target Channels for Scan in the List (List Scan)
4.3 Scan by Registering Multiple Target Channels for Scan in the
List (List Scan)
Using the List Scan enables the transceiver to scan the Zone-channels registered as a member in a Scan List.
If a scan starts in a zone where "List" is configured in Scan Type or on a channel where a Scan List Number is configured,
List Scan is executed. Or, if the transceiver is in the zone where "List" is configured in Scan Type and migrates to the channel
where a Scan List Number is configured during the scan, List Scan is executed.
Operating the transceiver
1
Press the Scan key.
The scan starts after a Key Beep A (1 beep) sounds from the transceiver.
The " " icon appears and then Revert Channel is displayed.
If "Scan" Displayed is enabled, "Scan nnn" (nnn indicates Scan List No.)
is displayed.
For portable transceivers, the LED light flashes according to the
configuration of Non-Priority Scan LED in the case of non-priority scan,
and according to the configuration of Priority Scan LED in the case of
priority scan.
Note
The transceiver behaves in the same manner even if the scan is started
by other method. (Refer to
2
Press the Scan key during the scan.
The scan completes after a Key Beep B (2 beeps) sounds from the
transceiver and the "
Note
If Selected Channel Scan is enabled, the selected channel can be scanned even if the channel is excluded from the
0
target channels for scan. (Refer to
If another zone is selected during the List Scan, the transceiver starts the scan according to the configuration in Scan
0
Type of the selected zone.
DMR FUNC (K, F)/Ver 2.20
Starting the Scan.)
" icon disappears.
Selected Channel Scan.)
Z o n e 1
C h a n n e l 1
S c a n
M en u Zo ne+
Z o n e 1
C h a n n e l 1
M en u Zo ne+
CONTENTS INDEX
A
12 : 34
M
1 2 8
A
12 : 34
M
137