Kenwood NX-5000 Series Function Reference page 86

1 DMR CONVENTIONAL SYSTEM
1.16 GPS Functions
1.16 GPS Functions
The following functions are relevant to GPS data transmission:
Number of Times
0
GPS Report Interval Time
0
GPS Time Mark
0
GPS Message Type
0
GPS Report on Data Zone-Channel
0
GPS Report on Data System-Personality
0
GPS Report Back to Requested ID
0
GPS Data Storage
0
Number of Times
Number of Times allows the transceiver to automatically send GPS data for the configured number of times if "Poll" is
configured for GPS Report Mode.
The transceiver sends GPS data for the number of times configured for Number of Times at the intervals configured for
GPS Report Interval Time.
Configuration using KPG-D1/ D1N
Configuring Number of Times (
GPS Report Interval Time
GPS Report Interval Time allows the transceiver to send GPS data at the configured intervals if "Auto" is configured for
GPS Report Mode.
GPS Report Interval Time (Portable/Ignition On)
GPS Report Interval (Portable/Ignition On) is the interval to send the GPS data while the vehicle's engine is running.
Also, in order to automatically send GPS data with Portable, this configuration is used.
GPS Report Interval Time (Ignition Off) (Mobile only)
GPS Report Interval (Ignition Off) is the interval to send GPS data while the vehicle is parked. Also, if the Ignition Sense
function is not used (nothing is entered in the Ignition Sense port), GPS data is sent according to the configuration in Ignition
Off. (Refer to Common FUNC
Sense).)
Note
GPS Report Interval Time is used to configure the trigger cycle to start sending GPS data. The timing at which the
receiving transceiver completes receiving GPS data may vary depending on the transmit conditions at the transmitting
transceiver.
DMR FUNC (K, F)/Ver 2.20
Transceiver Settings > Personal > Personal Features > DMR Conventional > GPS)
Turning the Transceiver ON or OFF According to the State of the Ignition Sense Port (Ignition
CONTENTS INDEX
69