Kenwood NX-5000 Series Function Reference page 58

1 DMR CONVENTIONAL SYSTEM
1.10 Sending and Receiving a Status Message (Status Call)
2
Press the [ ] key or
Refer to Common FUNC
selection methods.
3
Press the PTT switch or the
The transceiver sends the Status Message.
If the Status Message is properly sent to the target transceiver, "Complete"
appears.
Note
The selection screen for the Status List closes at the same time as
pressing the PTT switch or Menu ([Q]) key. If selecting an ID and sending
a Status Call again, reexecute the operations from step 1.
0
Sending a Status Message using Manual Dialing
To send a Status Message using Manual Dialing, Manual Dialing must be enabled using KPG-D1/ D1N.
1
Select one of the following operations to place the transceiver in Status Mode.
0
Press the Status key.
The transceiver enters Status Mode. In this case, a Status Message is
addressed to a Base ID.
0 Press the Individual + Status key.
Pressing the [F] key after selecting the Unit ID of the target transceiver
causes Status Mode to be entered.
0
Press the Group + Status key.
Pressing the [F] key after selecting the Group ID of the target
transceiver causes Status Mode to be entered.
Or, the transceiver enters Status Mode by pressing the Menu key or using
a keypad. In this case, the following operations are identical.
DMR FUNC (K, F)/Ver 2.20
[ ] key and then select the target data from the Status List.
"Selecting or Clearing Data from a
Menu ([ ]) key.
List" for
CONTENTS
A
12 : 34
M
Status 002
In Service
Call Office
Call Home
Se nd Bac k
A
12 : 34
M
Z o n e 1
C h a n n e l
S e n d D a t a
M en u Zo ne+
A
12 : 34
M
Z o n e 1
C h a n n e l
C o m p l e t e
M en u Zo ne+
A
12 : 34
M
Status 001
In Service
Call Office
Call Home
Se nd Bac k
41
INDEX