Kenwood NX-5000 Series Function Reference page 44

1 DMR CONVENTIONAL SYSTEM
1.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Individual Call Acknowledge Request)
2
Receive an acknowledgment message from the receiving transceiver.
The " " icon blinks, and the transceiver enters a state allowing
transmission of an Individual Call.
Receiving an acknowledgment message while the PTT switch is being
pressed initiates an Individual Call.
3
Press the PTT switch.
The Individual Call is initiated.
Note
If the Call Request Tone is enabled, a Call Request Tone (1 beep) sounds from the transceiver when a call request for
0
an Individual Call (Individual Call Acknowledge Request) is initiated. Also, if the Call Processing Tone is enabled, a Call
Processing Tone (2 beeps) sounds from the transceiver until the transceiver receives an acknowledgment message from
the receiving transceiver after the call request for an Individual Call (Individual Call Acknowledge Request) is sent. (Refer
to Notifying the User with a Tone That a Call Request Has Been Initiated (Call Request
Tone That a Call Request Is in Progress (Call Processing
If Call in Progress Tone is enabled, a Call in Progress Tone (2 beeps) sounds from the transceiver when the transceiver
0
becomes ready for transmissions with Individual Call.
If PTT Proceed Tone is enabled, a Proceed Tone (3 beeps) sounds from the transceiver when the transceiver becomes
0
ready for communications after the PTT switch is pressed. (Refer to Common FUNC
to Start Communications (PTT Proceed
While the transceiver is on standby to receive an acknowledgment message from the receiving transceiver, canceling
0
the call is possible by pressing the Clear key.
The transmitting transceiver sends a message requesting another acknowledgment when the length of time configured
0
in Maximum ACK Wait Time elapses without receiving an automatic response message for a message requesting an
acknowledgment from the receiving transceiver. If a response message cannot be received, the transmitting transceiver
can send a message requesting an acknowledgment up to the number of times configured for Number of Retries. (Refer
to Maximum ACK Wait Time,
The transceiver terminates the call if the transceiver cannot receive an automatic response message from the receiving
0
transceiver even if a message requesting an acknowledgment has been sent for the number of times configured in
Number of Retries. At that time, "No Reply" appears on the display for 1 sec. (Refer to
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Assigning functions to the AUX Input port (
0
Configuring Selcall on PTT (
on PTT)
0
Configuring Selcall on PTT (Channel Edit) (
Conventional > DMR > Selcall on PTT)
0
Configuring the Unit ID corresponding to the Call 1 to Call 6 key or port (
> Call)
DMR FUNC (K, F)/Ver 2.20
Tone).)
Number of Retries.)
Transceiver Settings > Extended Function > AUX)
Transceiver Settings > Personal > Personality > DMR Conventional > DMR > Selcall
Transceiver Settings > Zone/Channel > Channel Edit > DMR
Tone).)
Transceiver Settings > Key Assignment)
Transceiver Settings > Key Assignment
CONTENTS
12 : 34
I n d i v i d u a l
T R U C K 8 2 4
M en u Zo ne+
Tone), Notifying the User with a
Using Sound to Notify the Timing
Number of Retries.)
INDEX
A
M
27