Kenwood NX-5000 Series Function Reference page 38

1 DMR CONVENTIONAL SYSTEM
1.5 Making an Individual Call
Note
If Busy LED is enabled, the LED lights green when the transceiver is receiving. (Refer to Common FUNC
0
If Alert Tone is configured to sound when receiving, an Alert Tone will sound. (Refer to
0
receiving an Individual Call/ Paging
If Selective Call Alert LED or Optional Signaling LED is enabled, the LED flashes when the transceiver is receiving.
0
(Refer to Transceiver behavior when receiving an Individual Call/ Paging
The transceiver can send the ID of the transmitting transceiver from the communication port on the transceiver when
0
receiving an Individual Call/ Paging Call. (Refer to
Serial Output).)
Transceiver behavior when receiving an Individual Call/ Paging Call
0
Alert Tone
If the received Unit ID is configured in the Individual ID List, an Alert Tone sounds from the transceiver according to the
configuration of Alert Tone (Individual) or Alert Tone (Paging) for the corresponding Unit ID.
However, if "Common" is configured for Alert Tone (Individual) or Alert Tone (Paging) in the Individual ID List, or if the
received Unit ID is not configured in the Individual ID List, an Alert Tone sounds from the transceiver according to the
configuration of Alert Tone (Individual Call) or Alert Tone (Paging Call) used in common in a DMR Conventional
system.
0
Selective Call Alert LED
If the received Unit ID is configured in the Individual ID List, the LED flashes according to the configuration of Alert LED
Color (Individual) or Alert LED Color (Paging) for the corresponding Unit ID.
However, if "Common" is configured for Alert LED Color (Individual) or Alert LED Color (Paging) in the Individual ID
List, or if the received Unit ID is not configured in the Individual ID List, the LED flashes according to the configuration
of Alert LED Color (Individual Call) or Alert LED Color (Paging Call) used in common in a DMR Conventional system.
0
Optional Signaling LED
If Optional Signaling LED is enabled, the LED flashes in yellow. However, when Selective Call Alert LED is enabled,
LED will flash in accordance with the configuration of Selective Call Alert LED.
Also, when the transceiver key is operated while the LED flashes according to the Selective Call Alert LED configuration,
the LED flashes in yellow if the matching state of Optional Signaling persists.
Configuration using KPG-D1/ D1N
0
Configuring Selective Call Alert LED to be enabled or disabled (
> Conventional)
0
Configuring Optional Signaling LED to be enabled or disabled (
> Conventional)
0
Configuring Alert Tone (Individual)/ Alert Tone (Paging) (Individual ID List) (
Individual ID List > Alert Tone)
0
Configuring Alert LED Color (Individual)/ Alert LED Color (Paging) (Individual ID List) (
> DMR > Individual ID List > Alert LED Color)
0
Configuring Alert Tone (Individual Call)/ Alert Tone (Paging Call) used in common in a DMR Conventional system
( Transceiver Settings > DMR > DMR Information > Conventional > Alert Tone)
0
Configuring Alert LED Color (Individual Call)/ Alert LED Color (Paging Call) used in common in a DMR Conventional
system ( Transceiver Settings > DMR > DMR Information > Conventional > Alert LED Color)
DMR FUNC (K, F)/Ver 2.20
Call.)
Sending the Received Unit ID from the Communication Port (Unit ID
Transceiver behavior when
Call.)
Transceiver Settings > DMR > DMR Information
Transceiver Settings > DMR > DMR Information
Transceiver Settings > DMR >
Transceiver Settings
CONTENTS INDEX
Busy LED.)
21