Kenwood NX-5000 Series Function Reference page 172

4 SCAN
4.7 Scan Function
Note
If the Channel Recall key is pressed while no signal is received after scan starts, the transceiver migrates to the channel
0
from which the transceiver started scanning.
If Channel Recall is enabled, the transceiver does not resume the scan even if the time configured in Dropout Delay
0
Time or Dwell Time elapses.
Channel Recall is disabled if the channel is changed while Channel Recall is enabled. The transceiver resumes scanning
0
after the Key Delay Time elapses (1 sec).
The transceiver does not execute Lookback while Channel Recall is enabled.
0
If the scan is paused with Channel Recall and Scan Stop Tone enabled, the Scan Stop Tone (2 beeps) sounds from
0
the transceiver at 30-sec intervals.
The channel to which the transceiver migrated using Channel Recall is not configured as the Selected Channel.
0
Even if Channel Recall is enabled, the transmission using GPS Auto is executed by Revert Channel.
0
Configuration using KPG-D1/ D1N
Assigning functions to the PF keys on the transceiver (
Priority-channel Stop Tone
Priority-channel Stop Tone is the function that emits a Priority-channel Tone (1 beep) from the transceiver when the scan
is paused and the speaker is unmuted upon receipt of a signal on a Priority Channel during the scan.
Configuration using KPG-D1/ D1N
Configuring Priority-channel Stop Tone to be enabled or disabled (
> General)
Auto Scan
Auto Scan is the function to start the scan automatically by selecting the channel with Auto Scan enabled.
Whether to enable or disable Auto Scan can be configured for each channel. The scan on a channel where Auto Scan is
enabled cannot be stopped. The scan starts unconditionally if the transceiver migrates to a channel with Auto Scan enabled.
Note
If "Personality" is configured in Zone-channel Format for KPG-D1/ D1N, whether to enable or disable Auto Scan can
0
be configured for each Personality.
When the transceiver migrates to a channel where Auto Scan is enabled, the scan pauses if the conditions for starting
0
the scan are not satisfied.
If the transceiver migrates to a channel where Auto Scan is enabled after the scan is started by pressing the Scan key,
0
the scan cannot be terminated even if the Scan key is pressed.
In a zone where "None" is configured in Scan Type, the scan does not start even if the transceiver migrates to a channel
0
with Auto Scan enabled.
DMR FUNC (K, F)/Ver 2.20
Transceiver Settings > Key Assignment)
Transceiver Settings > Scan > Scan Information
CONTENTS
155
INDEX