Kenwood NX-5000 Series Function Reference page 129

2 COMMUNICATIONS IN AN EMERGENCY
2.8 Placing the Transceiver in Emergency Mode Using the Lone Worker Function
Duration of Lone Worker Tone
Duration of Lone Worker Tone is the length of time that the Lone Worker Tone (2 beeps) sounds from the transceiver.
If no key is pressed after the transceiver enters Lone Worker Mode and then Lone Worker Interval is activated, the Lone
Worker Tone (2 beeps) sounds from the transceiver when the time configured in Lone Worker Interval elapses. For the
time configured in Duration of Lone Worker Tone, the Lone Worker Tone (2 beeps) sounds from the transceiver. If no key
is pressed while the Lone Worker Tone (2 beeps) continues to sound from the transceiver, and if the time configured in
Duration of Lone Worker Tone elapses, the transceiver enters Emergency Mode.
If any key is pressed while the Lone Worker Tone (2 beeps) continues to sound from the transceiver, the Lone Worker Tone
(2 beeps) stops sounding, and Lone Worker Interval is reset, and then restarts counting down from the beginning.
Configuration using KPG-D1/ D1N
Configuring Duration of Lone Worker Tone (
Worker)
2.9 Placing the Transceiver in Emergency Mode by Using the
Activity Detection Function
Supported Models: Portable
Activity Detection is the function to detect the status of the transceiver by analyzing the behavior of the transceiver by
using the acceleration sensor and tilt sensor embedded in the transceiver, and to automatically place the transceiver in
Emergency Mode.
Using this function, if the transceiver detects that the transceiver is tilted, remains stationary, or moves vigorously for a
certain period of time due to an accident, the transceiver automatically enters Emergency Mode and notifies the base station
of the emergency status.
To use this function, Activity Detection must be enabled.
Operating the transceiver
0
Configuring Activity Detection to be enabled
1
Do either of the following operations while Activity Detection is disabled:
0
Press the Activity Detection key.
0
Select a channel where Activity Detection is enabled.
0
Press the Menu key to enter Menu Mode, and select "Activity Detection" and then select "On".
The "X" icon appears and Activity Detection will be enabled.
If Activity Detection is enabled by using the Activity Detection key or
the Menu key, the Key Beep A (1 beep) sounds from the transceiver.
DMR FUNC (K, F)/Ver 2.20
Transceiver Settings > Emergency > Emergency Information > Lone
Z o n e 1
C h a n n e l 1
M en u Zo ne+
CONTENTS INDEX
A
12 : 34
M
112