Kenwood NX-5000 Series Function Reference page 43

1 DMR CONVENTIONAL SYSTEM
1.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Individual Call Acknowledge Request)
Initiating an Individual Call (Individual Call Acknowledge Request)
An Individual Call (Individual Call Acknowledge Request) can be activated by one of the following methods.
0
Individual Call Mode
Selecting a Unit ID configured in the Individual ID List or directly entering a Unit ID while the transceiver is in Individual
Call Mode, and then pressing the PTT switch or the Menu ([Q]) key sends a message requesting an acknowledgment.
Pressing the Individual, Individual + Status, or Individual + Short Message key places the transceiver in Individual
Call Mode.
The transceiver also enters Individual Call Mode by selecting "Individual", "Individual + Status", or "Individual + Short
Message" after the transceiver enters Menu Mode by pressing the Menu key. (Refer to Common FUNC
Mode.)
If "Individual", "Individual + Status", or "Individual + Short Message" is configured in Keypad Operation, pressing the [0]
to [9] keys on the keypad also places the transceiver in Individual Call Mode. The transceiver enters Unit ID Shortcut
Entry Mode or will be on hold as the first digit of the Unit ID is entered. (Refer to Common FUNC
0
Stack Mode
Selecting the receive record in Stack Mode and then pressing the PTT switch sends a message requesting an
acknowledgment. (Refer to Common FUNC
0
Selcall on PTT
Selecting the channel where the target Unit ID for Selcall on PTT is configured and then pressing the PTT switch sends
a message requesting an acknowledgment. The Unit ID of the target transceiver can be configured by selecting one Unit
ID from the Individual ID List by using KPG-D1/ D1N.
0
Call key
Pressing one of the Call 1 key to the Call 6 key sends a message requesting an acknowledgment to the Unit ID which
corresponds to the key pressed.
For Mobile, a message requesting an acknowledgment is sent to the Unit ID which corresponds to the active port when
any of the "Call 1" to "Call 6" ports allocated to the AUX Input port becomes active.
0
PC command
A message requesting an acknowledgment is sent when the PC command is received from the communication port. To
use a PC command, "Data" or "Data + GPS Data Output" needs to be assigned to the communication port of the
transceiver. (Refer to Common FUNC
Operating the transceiver
1
Follow one of the methods mentioned above to initiate an Individual Call (Individual Call Acknowledge
Request).
A message requesting an acknowledgment is sent.
When the receiving transceiver is inside the communication range,
"Calling" appears on the display, and the transceiver waits to receive an
acknowledgment message from the receiving transceiver.
DMR FUNC (K, F)/Ver 2.20
Viewing the Receive History
Available Functions for COM
(Stack).)
Port.)
I n d i v i d u a l
T R U C K 8 2 4
CONTENTS
Using Menu
Keypad Operation.)
A
12 : 34
M
C a l l i n g
26
INDEX